The lubrication unit complete 2 (fig. 38) mainly consists of a transparent grease container 13, and an electric motor 14 driving a lube pump 15. The optional mounted automatic lubrication pump also comprises a control unit 16 (fig. 44) which starts and stops the lubricating procedures. SERIALLY MOUNTED SEMI AUTOMATIC SYSTEM OPERATION OF THE SEMI AUTOMATIC SYTEM In the semi automatic system, the pump is controlled by the push button S84 on the rear control desk of the driver's cab. Depressing the button S84 alternately turns on and off the lube pump. When the pump is greasing, the indicator lamp inside the button lights up.
To lubricate, turn on the button S84 and keep the pump running until clean grease runs out of the bearing points boom cylinders to upper carriage (fig 33, pos. 10). LUBRICATION INTERVALLS Under normal working conditions a semi automatic lubrication must be performed daily. If the machine is used under hard conditions (working under water, in very abrasive material, ) or in multi shift service, lubricate more often (up to once a working shift or every 4 hours). OPTIONAL MOUNTED AUTOMATIC SYSTEM FUNCTION During a lubricating procedure, all lube points are lubricated one after the other in a certain sequence (progressive system).
After completion of a lubrication procedure, the pump is turned off by a proximity switch 7 (fig. 49) mounted to a distribution element of the main distributor 4. At each stroke of a piston in this element, the switch 7 gives a pulse signal to the control unit 16, which stops the lubricating procedure as soon as the preadjusted number of strokes has been reached. 39 During lubrication, the delivery of grease can be checked visually while observing that the indicator stem 27 mounted to the top of the main distributor 4 (fig. 39) moves alternately in and out.
The flow sequence and amount of lubricant for each lubrication point depend on the combination of the distributors and lubrication lines and of the piston size of the distribution elements. OPERATION OF THE LUBRICATION SYTEM After turning on the excavator the control light inside the touch S84 (fig. 40) and the green LED 17 (fig. 41) light up for approx. 1,5 sec. to show that the electric pump is operative. A lubrication procedure will begin automatically after a "cycle time" is over and stop after all points have been lubricated, this without any action by the operator. 5.20 38