Liebherr — R934B_en_sn_17227.mdi

MENU a) ALLOCATION OF FLOW LIMIT OPTIONS TO EXTERNAL INPUTS I1 (Special attachment input; as an example when operating a hammer pedal) In this menu, pre-defined flow limitations (options) are allocated to the hardware input I1. The arrow near the symbol gives the actual allocation (Fig. 65a and Fig. 65b). In example beside, the option 3 is active for the input I1, this means, if the external hardware input I1 is activated, then the nominal pump values allocated in option 3 for the excavator control are given as maximum nominal values.

If another option must be allocated to input I1 (as an example due to a modification of the working attachment), so first select another attachment in the vertical symbol range via the key "UP" or "DOWN", as for example Option 10 in Fig. 65b 65 Confirm the selected option by pressing the "MENU" key, the new option must then appear in the column. The right part of the screen provides indication for the currently set pump values corresponding to the option shown in the selection window. The values EV1 up to EV3 determines the initiated working pump flow limitation while additional attachment operating 66 Notice :

- The pump choice EV2 does not appear for Load Sensing machines R 904 up to R 924. - The pump choice EV3 appears only for machines provided with 3 separetely adjustable working pumps (R984, Special machines, ...). The value EV6 determines the permitted maximal pressure level for the additional attachment feeding. The value after "Quota" choice has no importance for crawling excavator. While choosing an option appears in the lower section of the screen its designation, if it has been defined on option parameterisation. As example on fig.66 appears "HM2000", option designation allocated to the hydraulic hammer. 3.17.1