Liebherr — R934B_en_sn_17227.mdi

MACHINE OPERATING SAFETY Familiarize yourself with job site rules. Be informed about traffic and hand signals and safety signs. Ask who is responsible for signalling. Check your surrounding for any obstacles in the working and movement range, check the load carrying capacity of the terrain, and secure the job site to shield it from any public highway traffic. Rope off the working area of the machine and install the necessary signs to forbid any non authorized person entering the area. corrected immediately. Do not move the excavator until you are certain that no one is endangered by moving the excavator.

On machines without negative brakes check the brake system before starting to work, as outlined in the Operation and Maintenance Manual. Never leave the operator’s seat while the machine is still moving. Always keep a safe distance from overhangs, walls, drop offs, and unstable ground. Never leave the machine unattended (within view of machine), with the engine running. Be alert of changing weather conditions, bad or insufficient visibility and of changing ground conditions. When moving the excavator, keep the uppercarriage in lengthwise direction and keep the load as close as possible to the ground.

Be alert for utility lines, check the location of underground cables, gas and water lines, and work especially careful in that vicinity. If necessary and/ or if required, call local authorities to mark the location, and take precaution against contact with underground utilities. Prevent any working movements, which could tip the machine over. If the excavator begins to tip or slip on a grade, immediately lower the attachment and load to the ground and turn the excavator facing downhill. If possible, always operate the excavator with the attachment positioned uphill or downhill, never sideways. Keep sufficient distance to electrical lines.

When working in the vicinity of high voltage electrical lines, keep proper distance to assure that the attachment does not come close to the lines. DANGER! You must inform yourself about safe distances. Preferably have the electrical lines de-energized (and lockout / tagged out according to the regulations applicable on the job-site) each time it is possible, and in any case if the closeness of the working area make it necessary. Always travel slowly on rough or slippery ground and on slopes, and on loose soils. Always travel downhill at permissible speed, so you don’t loose control over the machine.

The engine must run at nominal speed, use only the foot pedals to brake and slow down the machine. Never shift during down hill travel, always shift to a lower gear before travelling downhill. In case you do touch a high voltage line by accident, proceed as follows: - do not leave the machine, - move the machine, if possible, from the danger zone until you obtain sufficient distance, - warn any personnel in the vicinity not to come close to the excavator and not to touch it, - instruct or initiate that someone turns off the voltage. - Do not leave the machine until you are absolutely sure that voltage in the line, which had been touched or damaged, has been turned off!

Load an occupied truck only if all safety requirements are fulfilled, notably in order to protect the truck operator. For demolition work, clearing, crane operation, etc. always use the appropriate protection device designed for this specific application. If operating in visually obstructed terrain or whenever necessary, have another person guide you. Always have only one person signal you. Allow only experienced persons to attach loads or to guide operators. The guide must be visible by the operator and / or must be in voice contact with him. Before moving the machine, make sure that the attachments and equipment is secured properly to avoid accidents.

Depending on the attachment combination, it is possible for the bucket teeth to hit the cab, the cab protection or the boom cylinders. Be very careful when the bucket teeth get in this range to prevent any damage. When travelling on public roads, make sure to observe traffic regulations, and make sure that the machine meets federal and local public highway standards. In case of a thunderstorm: - lower the attachment to the ground and if possible anchor the digging tool into the soil. - leave the cab and move away from the machine before the storm breaks out. Otherwise, you must stop the excavator, turn off the radio and keep inside the closed cab until the end of the storm.

Always turn on the lights if visibility is bad or if you are still working during dusk. Never allow other personnel on the excavator. Operate the excavator only while seated and with the seat belt fastened, if installed. Report any problems or needed repairs to your foreman or supervisor and make sure they are 4.9