Komatsu — AFTER STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS OPERATION MACHINE OPERATIONS AND CONTROLS 16. Before starting operations, repeat the following operations slowly 3 to 5 times to circulate warm oil through the control circuits. 3 - 139 14. Turn fuel control dial (3) t o the full sp eed (MAX) p osition, repeat Steps 5 to 8 for 3 to 5 minutes, t hen check a gain that the hydraulic correct temperat If it is not displaying the c orrect temp erature, rep eat Steps 5 to 8 for 3 to 5 minutes until hydraulic o il temperatu re monitor (6) displays t he correct (A) Display when temperature is co rrect: Monito r background (C) is b lue ckground (C) (B) Display when temperature is low :

Monitor ba is white For both nor mal temperatur es and cold temperature s, carry ou t the following ope 15. Check th at fuel control di al (3) is at a point midwa y between l ow idling (MI N) and full spe ed (MAX). If it is not at the midway position, se t it to the mi dway position and run t he engine at a mid-range s peed before operating Boom operation R AISE (E) ← → LOWER ( Arm o peration IN ( B) ←→ OU T (A) Bucke t operation C URL (D) ← → DUMP (C Swing operation L eft (G) ←→ Right (H)