Komatsu — BUCKET REPLACEMENT AND INVERSION

. OPERATION MACHINE OPERATIONS AND CONTROLS Inversion WARNING 1. Place the bucket in contact with a flat surface. 3 - 166 Whe overruns the normal trajectory and i nterferes with the cab, thus causi ng a serious trouble. Pay good attention t o the work when reversing a bucke t so that the bucket and the cab may not REMARK When removing the pins, place contact with the ground. the bucket so that it is in light to the ground, the resistance will If th e bucket is lowered strongly will be i ncreased and it will be difficu lt to remove the pins. NOTICE Afte r removing the pins, make sure t hat mud or sand does not get on th em.

Dus t seals are fitted at both ends of t he bushings, be careful not to damage the m. Remove the double nut on th e stopper bolt for arm pin (A) and link pin (B), remove the bolt, p ull out arm pin (A) and link pin (B), and then remove the bucket . Turn the removed bucket. A fter turning the bucket, align the arm (5) with link (6) mountin g hole (1), then align the link (6) 2) and install. (6) with arm (5) mounting hole ( Insert grease-coated pins (A ) and (B) into hole (1) and hole (2) respectively.