. OPERATION TROUBLES AND ACTIONS TOWING THE MACHINE WARNING 3 - 192 Serious injury or death could r esult if a disabled machine is towed incorrectly or if there is a mistake in the selection or inspection of the wire rope. Always check that the wire rop e used for towing has ample strength for the weight of the machine bein g towed. Never use a wire rope which ha s cut strands (A), reduced diameter (B), or kinks (C). There is danger th at the rope may break during the towing operation. en handling wire rope. e. Always wear leather gloves wh Never tow a machine on a slop During the towing operation, n ever stand between the towing machine and the machine being towed.
Operate the machine slowly an d be careful not to apply any sudden l oad to the wire rope. NOTICE this machine is 5,140 kg (50,400 N). The maximum towing capacity for this machine is 5,140 kg (50,400 N). Always carry out towing operation s within the maximum towing capacity. If the machine sinks in mu d and cannot get out under its o wn power, or if the drawbar pull of the excavator is being used to tow a heavy object, use a wire r ope as shown in the diagram on the right. Place pieces of wood betw een wire ropes and body to prevent damage to ropes and body. Hold the wire rope level and direct it straight to the track frame.
When towing a machine, tra vel at a speed of less than 1 km/h for a distance of only a few m carrying out repairs. eters to a place that is suitable for gencies. This is for use only in emer SEVERE JOB CONDITIO N When carrying out digging o perations in water, if the work equipment mounting pin goes into the water, carry out greasing every time the ope ration is carried out. For heavy-duty operations a nd deep digging, carry out greasing of the work equipment moun ting pins every time before operation. om, arm, bucket and blade several times, then grease again. After greasing, operate the bo om, arm, bucket and blade several times, then