. MAINTENANCE MAINTENANCE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING The coolant has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. As a basic rule, we do not recommend the use of any coolant other than Komatsu genuine supercoolant (AF-NAC).
If you use another coolant, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%. When deciding the ratio of antifreeze to water, check the lowest temperature in the past, and decide from the mixing table given below. It is actually better to estimate and temperature about 10 ° C (18 ° F) lower when deciding the mixing ratio. The mixing ratio depends on the ambient temperature, but it should always be a minimum of 30% by volume (antifreeze/total amount of coolant x 100).
Even in areas where it is not necessary to prevent freezing, use Supercoolant (AF-NAC) at a mixing ratio of at least 30% to prevent corrosion of the cooling system. The freezing temperature of undiluted antifreeze is -15 ° C (5 ° F). Do not store undiluted antifreeze at a temperature of below -15 ° C (5 ° F). 4 - 22 Immediately after th e engine is stopped, the coolant is at a high t emperatur e an d th e radiator is under high internal pressure. If th e ca p is r emoved to drain th e coolant i n this condition, there is a hazard o f burns. Wait for t he temperature to g o down , then turn the cap slowly t o release t he pressu re before removin g it.
Cleanin g is carried o ut with the engine ru nning. When standing u p or leaving the operator's seat, set the lock lever to the LOCK position . For details o f startin g the engi ne, see "B EFORE STARTING ENGI NE (PAGE 3-110)" a nd "STARTING ENGINE (PAGE 3-129)" in the OPERATION sec tion. The engine i s operat ed when w ashing, so it is d angerous if the m achine moves whe n you are standing behind it. Never stand behind t he machine when the engine is r unnin g.
Stop t he machine on level ground whe n cleaning o r changin g the coolant Clean the inside of t he cooling system, change the coolant a ccording to t he t able below Antifreeze coolant Interval for cleaning inside of cooling system and changing antifreeze coolant Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first