. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 24 4. Remove center cover (4) and 5. Check that the cooling wat er temperature has gone down enough to make it possible to touch the radiator cap surface by hand, then turn radiator ca p (6) slowly until it contacts the re. stopper to release the pressu 6. Following this, push radiator cap (6), turn it until it contacts the 7. stopper, then remove it. Place a container to catch t he coolant under the drain hose installed to drain valve (7) an the engine cylinder block. d under coolant drain plug (8) on 8. Open drain valve (7) at the bo ttom of the radiator and drain the water.
Remove drain plug (8) in the c ylinder block and drain the water. 9. After draining the water, clos e drain valve (7) and tighten drain plug (8), then fill with city wat er. 10. When the radiator is full, start Keep the engine running at the engine, and run it at low idle. low idle for 10 minutes until the ore than 90°C (194°F). drain valve (7) and remove drain water temperature reaches m 11. Stop the engine, then open plug (8) to drain the water. 12. Close drain valve (7). Wind s eal tapes onto drain plug (8), then tighten it. Install covers (2) and (4). 13. 14. Fill with super coolant and ta p water through the water filler up to the bottom of the filler.
For details of the mix ratio for super coolant and water, see MIX RATIO CHART FOR WATE R AND SUPER COOLANT. 15. To bleed the air from the cool ing system, run the engine at low idle for 5 minutes, and for a further 5 minutes at high idle. adiator cap off.) (When doing this, leave the r