. MAINTENANCE MAINTENANCE PROCEDURE Adjustment WARNING 4 - 27 CHECK AND ADJUST TRACK TEN (Machine eq uipped with steel shoes, roa The wear of the pins and bushings on th orking c onditions and type of soil, so inspect the t rack tension frequently in or der to maintain the standard tension Stop the ma chine on firm, horizontal gro und when carrying out the inspectio n and m Checking engine at low idle, move the machine forward a 1. Run the distance machine 2. Choose roller (2) 3. Measure the track Stand Deflec 1. Run the equal to the length of track the 2. Choose wooden block (3) that will rea ch from idler (1) to carrier , then place it on top of the t rack.
tween the top surface of he wooden block. mm (0.4 to 1.2 in). 3. Measure the maximum deflection be and the bottom surface of t ard deflection tion "a" should be 10 to 30 If the track te nsion is not at the standard value, adjust it in the following man There is dange grease. Never r of plug (4) flying out under the loosen plug (4) more than 1 tu high internal pressure of the rn. Never loosen mounting dire any part other than plug (4). ction of plug (4). nsion cannot be loosened with Never put your face in the the procedure given here, If the track te please contac t your Komatsu distributor. Increasing Track Tension Prepare a grease pump. Prepare a gr 1. Pump in 2.
To check idle, mov of track 3. Check th adjust it 1. Pump in grease through grease fittin g (5) with a grease pump. 2. To check that the track tension is cor rect, run the engine at l ow e the machine forward a dis on ground, then stop the ma tance equal to the length chine. e track tension again, and if the tension is not correct, again.