Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE below, it will cause tooth (1) to come off during 4 - 37 I f l ock pin (2) and rubbe r pin lock (3) are used i operation. Always repla The lock pin (2) is too Dimension (B) is 1/3 o r more of dimension (A) when l ocking pin (2) is aligned with bot Rubber (6) of the rubb er pin lock is cut and t he s teel b all is about to c ome out. Ste el ball (7) sinks in when it is pushed by han 5. Cl ean the surface of adapter (4) and remove the so il with a 6. U se your hand or a h ammer to push rubbe r pin lock ( 3) into the le of the adapter ( hen doing this, be careful that the rubber pin lock (3 ) does not out from the adap 7.

Cl ean the inside of t eeth (1), then install it to adapte r (4). I f there is mud affixed t o it or if there are prot rusions e teeth (1) will not enter the adapter properl y, and there will not b e proper cont act at t he mating port