. MAINTENANCE MAINTENANCE PROCEDURE low not 2) Run the engine at low idling, and make a swing movement slowly to the right and left more than twice each 4 - 51 4. Bleeding air from NOTICE If the engine is run at hi gh speed immediately aft er startup or a cylinde r is pushed up to its stroke end, air taken inside the cylinder may cause damage to t 1) Run the engi ne at a mid-range spe ed (1650 rpm ) and exten d and retract the cylind ers 4 to 5 times to a poin 100 mm (3.9 in) from the end of th e stroke. (B e caref ul no t to operate to the end of the stroke.) emove the air. 2) Next, operat e each cylinder 3 to 4 times to the end of its stroke.
3) Finally, oper ate each cylinder 4 to 5 times to th e end of its stroke to completely r 5. Bleeding air from (Carry out only if the oil inside the swin g motor cas e has been NOTICE If the air is not bled fro m the swing motor, the m otor bearing s may b 1) Loosen hose (3) while keeping the engine running at idling. Tighte n it again once oil st arts to flow attempt to m ake a swing moveme nt at that tim 6. Bleeding air from swing PPC circuit i Bleed air thro nside the cov ugh air bleeder (4) ins er on the right side of talled to the machine. 7.
Bleeding air from travel motor (only when oil in 1) Run the engi then when th (only when oil in side travel motor case has been d rained) 1) Run the engi ne at low idling, remov e hose (5) f rom po then when th e oil has flowed out, ti ghten it aga