Komatsu — EVERY 250 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE battery, or there is no display of the UPPER installed on top of the battery. 3. After adding distilled water, tighten cap (2) securely. 4 - 60 . If the el ectrolyte level is below the midway point between the UPPER LEVEL (U.L.) and LOWER cap (2) and add purified water (e replenishment water for a battery) t LEVEL (U.L.) and LOWER LEVEL (L.L.) lines, remove and add purified water (e .g. commercially available o the U.L. line. cap (2) securely. .

After ad ding distilled water, tighten REMARK ater is added to above the UPPER LEVEL (U.L.) line, If d istilled w ater is added to above the us e a syrin ge to lower the level to the UPPER LEVEL (U.L.) line. Neutralize the removed fluid with baking soda (sodium large amount of water or tery maker. bicarbonate ), then flush it away with a consult you r Komatsu distributor or bat When it is Impossible to Check Electrolyte Level from Side of Battery If it is impo ssible to check the electrol the LEVEL line on the side of the battery, c . Open t he battery inspection cover, . Remov e cap (2) at the top of the bat tery, look through the water filler p electrol (e.g.

co so that LEVEL ort (3), and check the e yte does not reach the sle lectrolyte surface. If the eve (4), add purified water mmercially available repleni shment water for a battery) the level reaches the bott line) without fail. om of the sleeve (UPPER (A) Suitable level: Electrolyte level is up to bottom of sleeve, so surface tension ca bulge and poles a uses electrolyte surface to ppear bent. (B) Low: Electrolyte level is not up to bottom of sleeve, so poles REMARK If w ater is a dded to above the bottom tip of the sleeve, use a pipette to remove electrolyte. Neutralize the removed electrolyte with sodium bic arbonate, then flush it awa water. If n battery mak