Komatsu — EVERY 500 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE LUBRICATING 4 - 65 EVERY 500 HOURS MAINTENANC Maintenan ce for every 100 and 250 hours s hould be carried out a NOTICE I f any ab normal noise is ge nerated from any g reasing point, carr y out g reasing regardless of the g Carry ou t greasing every 10 hours for the first 50 hours o n a new After the machine was subj ected to jobs in th e water, be sure to grease Prepare a grease pump e greasing posture shown on the right rk equipment to the ground, then stop , pump in grease through the grease s. f any old grease that was pushed out. 1. 2. 3. 1. Set th e machine to th diagra the en m, lower the wo gine. a grease pump 2. Using fittings shown by arrow 3.

After g reasing, wipe of f any old grease tha t was p ushed shown on the right the hen stop (1) Boom foot pin (2 places (2) Boom cylinder foot pin (3) Boom cylinder rod end (4) Arm cy linder foot pin (2 (5) Arm cy linder rod end pi (6) Boom - Arm coupling pi (7) Bucket cylinder foot pin (8) Arm - Link coupling pin