. MAINTENANCE MAINTENANCE PROCEDURE the dipstick (G). REPLACE FUEL PRE-FILTER CARTRIDGE WARNING 1. Open the engine hood. 2. Set valve (1) at the side of the fuel pre-filter cartridge to the shut position (S). 3. Set the container to catch the fuel under the pre-filter cartridge. 4. Loosen drain valve (2), then drain all the water and sediment in the transparent cap (3) and also the fuel accumulated in filter cartridge (4). 5. Using a filter wrench, turn transparent cap (3) to the left to remove it. (This cap is used again.) 6. Using a filter wrench, turn cartridge (4) to the left to remove it. 4 - 68 7.
After replacing the filter c artridge, add oil through oil filler (F) un til the oil le vel is be tween the H a nd L marks on 8. Run the engine idle for a while, then stop the engine and confir m that the oil level is between th e H and L lines evel in Engine Oil Pan, Add Oil (PAG After the engine has been ope rated, all parts are at high temperature, so do not repla ce the filt er immediately. Wait for all parts to cool down before starting t he operation. side the engine fuel piping system when the engine is running. High pressure is generated in side the engine fuel piping system when t he engine i s running.
When replacing the filter, wai t for at least 30 seconds after stopping th e engine to let the in ternal pressure go down before replacing the filter. close. Do not bring any fire or flame NOTICE Genuine Komatsu fuel filter c artridges use a special filter that has high ly efficient filtering a bility. When re placing the filter cartridge, always use a genui ne Komatsu part. The common rail fuel injectio n system used on this machine consists o f more pre cise parts than the conve ntional injection pump and nozzle. If any part other than a genuin e Komatsu filter cartridge is used, dust or dirt may ge t in and c ause problems w ith the injection system. Always avoid using substitute parts.
When carrying out inspection or maintenance of the fuel system, pay m ore attentio n than no rmal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely. Prepare a container to cat Prepare a filter wrench