. MAINTENANCE MAINTENANCE PROCEDURE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS,FUEL COOLER FINS, AND AIR CONDITIONER CONDENSER FINS WARNING NOTICE 4 - 73 If compressed air, high-pressure wat er, or steam hits your body directly o r dirt is sent flying by the com pressed air, high-pressure water, or steam, there is danger of p ersonal injury. Always wear protectiv e glasses, dust m ask, and ot her protective equipment. When use the compressed air, keep a distance from air nozzle, to preven ts damage to the To prevent damage to the fins, apply compressed air from and appropria te distance . Damaged fins m ay cause water leaka ge or overheating.
In a dusty site, check th e fins daily, irrespective of the maintenance interval. 1. Open the engine hood and t he battery inspection cover at th left side of the machine. nd remove net (2). 2. 3. Remove 4 wing screws (1) a Clean net (2). 4. Check the front and rear surf aces of oil cooler fins (3), radiato fins (4), aftercooler fins (5), A ir conditioner condenser fins (6) and fuel cooler fins (7). If the re is any mud, dirt, or leaves stuc to the fins, blow the dirt off w Steam or water may be u However, when carrying ith compressed air.
sed instead of compressed air out powerful steam cleanin ash) of the heat exchang ler, aftercooler, fuel cooler, ai ntain sufficient distance from th (high-pressure machine w equipment (radiator, oil coo conditioner condenser), mai machine when carrying out (high-pressure machine was the operation. If steam cleanin h) is carried out at close range ernal fins of the heat exchang there is danger that the int equipment may be deformed , and this will cause early cloggin 5. and breakage. Check the rubber hose. Rep lace with a new one if the hose i found to have cracks or to b Also, check hose clamps for 6. After completing inspection a nd cleaning, install net (2) to its original