. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE out, then pump it in REMARK It is not necessary to remove the plug at the top of the fuel runs out of fuel, use the same procedure to operate feed pump (4) and bleed the air. 11. Push in the knob of feed pump (4) and tighten it. 4 - 83 Replace inner s NOTICE filter cartridge with fuel. Do not fill the new Remove cap (B) a nd install the filter cartridge. 6. When installing , tighten until the packing surface contacts the seal surface of the filter h older, then tighten it 3/4 of a turn. If the filter cartr idge is tightened too far, the packing will be damaged and this will lead to leakage of fuel.
If the filter cartridge i s too loose, fuel will also leak from the packing, so always tighten the c orrect amount. 7. Set valve (1) a t the side of the fuel pre-f ilter cartridge to the open position (O). r cartridge (2), bleed the air. 8. After completin g the replacement of filte Bleed the air as fol 9. Fill the fuel tan k with fuel (to the position 10. Loosen the kn ob of feed pump (4), pull and out until th e movement becomes he pre-filter and fu After the engin 12. After replacing the filter cartridge, start t he engine and run it at low idling for 10 minute Check for leak age of oil from the filter sea l surface. If any oil is leaking, check the tighten ing of the filter cartridge.
If there is still oil leakage, repeat Steps 2 - 4 to remove the filter cartridge, and if any damage or embedded foreign materia l in the packing surface is found, replace it with a new cartridge and repe at Steps 5 - 12 to install it.