. MAINTENANCE MAINTENANCE PROCEDURE WARNING circuit. Even go down CHECKING FUNCTION OF ACCUMULATOR (arm fully the work 4 - 89 CHECKING CHARGE PRESSURE OF NITROGEN GAS IN ACCUMULATOR (F CIRCUIT) The ac cumulator is charged wit h high-pressure nitrogen gas, so mistaken operation may cause a n explosion, which will lead to seriou s injury or damage. Whe n handling the accumulator, alw ays do as fo llows. The pressure in the hydrauli c circuit cannot be completely removed. W hen removing the hydr aulic equipment, do not stand in t the he direction that the oil s purts out when carrying out the operation. I n addition, loosen the b olts slowly when carrying out operation. umulator.
dispose of it in fire. eld it. t it to any impact. Do not disassemble the acc Do not bring it near flame or Do not make holes in it or w Do not hit it, roll it, or subjec Wh en disposing of the accu mulator, the gas must be rele ased. Please contact your Komatsu distributor to have this work car ried out. FUNCTION OF ACCUMUL The a ccumulator stores the after t the fo he engine is stopped, llowing actions are po If t eq un he control lever is ope uipment, it is possible der its own weight. Th e pressure in the hydr aulic circuit can be released The a ccumulator is installed to the position shown in th on th e right.
Repla ce the accumulator ev ery 2 years or every 4000 h ours, whichever comes sooner Chec k the nitrogen gas cha 1. S 2. S e e 1. S top the machine on fir 2. S et the work equipme xtended and bucket quipment at a position 1.5 m (4 ft 11 in) above the NOTIC E out the following procedure to lower the work equipment to the ground within 15 seconds of stopping the engine. Carry out the following proced ure to lower the work equipmen t to the grou nd within 15 seconds o When the engine stops, the pre ssure in the accumulator gradu ally goes dow n, so inspection can o nly be carried out immediately after t he engine is stopped.