. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE plug (P). 4 - 94 5. Open mud cover (1 ). 6. Loosen bolt (2), the n remove plate (3) on top of oil filler port (F). 7. Remove the cap fro m oil filler port (F), and rele ase the internal pressure. 8. Place a container u nder the drain plug which i s located on the machine underside . Then remove drain plug (P), using a il. k the O-ring fitted to drain plug (P) and a handle, and drain o At that time, chec replace it with a ne draining oil, tighten w one, if any damage is f drain plug (P) again. ound on it. After 1 Nm , 51 ± 7 lbft) Tightening torque of the drain plug:
68.6 ± 9.8 , 51 ± 7 lbft Take care not to get oil on yourself when y ou remove drain 9. Remove bolts (4), t hen remove cover (5). Wh en this is done, the cover may fly of f under the force of spring (6), so keep the cover pushed down when removing the bolts. 10. Pul l up the top of ro (6) and strainer (8). 11. or f If s trainer (8) is bro ken, replace it with a new p 12. When installing, ins ert strainer (8) into tank pr otruding portion (9), and assemble. sition, hold it down by hand, and tighten ts (4) to install cover (5). stalled to the cover, and if it is damaged, 13. Set cover (5) in po cover mounting bol Check the O-ring in replace the O-ring. 14.
Ad d the replaceme nt amount of oil through oil filler (F). Check tha between the H and L lines on the sight For details of oil lev el check, see "Check Oil Le vel in Hydraulic Tank, Add Oil (PAG E 3-115)". in clean ligh t oil