. ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT tank. 6 - 12 5. Open mud cover (1). 6. Loosen bolt (2), then remove plate (3) on top of oil filler port (F). 7. Remove the cap from oil fille r port (F), and release the internal pressure. 8. After checking that the hy draulic oil temperature has g one down, set the rotor of the st the outlet port and inlet po LOCK position (b). (a) FREE: Hydraulic oil flow long direction of (b) LOCK: Hydraulic oil doe right angles to lo down, set the rotor of the st op valve (installed to the pipin g for the outlet port and inlet po LOCK position (b).
rt on the side face of the arm) to s (direction of arrow is parallel to arm) s not flow (direction of arrow is at ng direction of arm) When setting the FREE o rotor, remove bolt (2), tur After setting, install plate When setting the FREE o r LOCK position of the stop v alve n over plate (1), then turn the r otor. (1) again with bolt (2). 9. Remove the hoses on the a ttachment side. Install the plug s to the two outlets. The plugs are used to prev ent the attachment from incorrect operation caused by mixing in of foreign matter. After the p lugs are correctly installed, store the attachment. 10. Pull out the mounting pins ( 2 places), remove the attachment, then install the bucket.
re for installing the bucket, see T AND INVERSION (PAGE heck the oil level in the hydraulic For details of the procedu "BUCKET REPLACEMEN 3-165)". After installing the bucket, c 11.