Komatsu — CONTROL PATTERN CHANGE PROCEDURE

. ATTACHMENTS AND OPTIONS CHANGING MACHINE CONTROL PATTERN (IF PATTERN CHANGE VALVE EQUIPPED) CHANGING MACHINE CONTROL PATTERN (IF PATTERN CHANGE VALVE EQUIPPED) WARNING 3. Follow the steps explained below, when switching the patterns. tool to select either ISO 3) 6 - 20 When ch anging the operat ing pattern o f the m achine, s et the machine in the parking posture, stop the engine, check that the lock lev er is at the LOCK p osition, the n chang e the operating pattern.

To preve nt personal injury caused by m istaken operatio n, test operate t he machine and check that th e display on the operating pattern card is the same a s the movement of t he machi If it is no t the same, replac e the operating patt ern card i mmediately with the card that matches the When ch ecking the movem ent of the m achine, check c arefull y that the surrounding area is safe, an CONTROL PATTERN CHANGE PROCEDURE 1. After setting the machine in the parking posture, set the lock lever to the LOCK position, then stop the engine. 2. Open the inspection cover on the left side of the machine. The selector valve is inside. 1.

After s etting the mach ine in the p arking posture, set t he lock l ever to the LOCK position , then stop the engine. 2. Open the inspection c over on the left sid e of the machine. The or valve is insid osen wing bolt ( ove lever (2) w ttern (A) or Bac khoe patter 45. Start t he engine, set th e lock leve r to the FREE position, operat e the work equipment le vers slowly, and check e operating patt ern has changed.