32 SEBU8726-03 Operation Section Lifting and Storage Operation Section Some removals require lifting the fixtures to obtain correct balance and safety. Lifting and Storage To remove the engine, use the lifting eyes that are on the engine. Radiators that are approved by Perkins can be lifted with the engine. i06704010 Product Lifting Lifting eyes are designed and installed for specific engine arrangements. Alterations to the lifting eyes and/or the engine make the lifting eyes and the lifting fixtures obsolete. If alterations are made, ensure that correct lifting devices are provided.
Consult your Perkins dealer or your Perkins distributor for information regarding fixtures for correct engine lifting. Note: The engine is equipped with three lifting eyes. All the lifting eyes must be used to lift the engine. i04084189 Product Storage (Engine and Aftertreatment) Perkins are not responsible for damage which may occur when an engine is in storage after a period in service. Your Perkins dealer or your Perkins distributor can assist in preparing the engine for extended storage periods. Condition for Storage The engine must be stored in a water proof building. The building must be kept at a constant temperature.
Engines that are filled with Perkins ELC will have coolant protection to an ambient temperature of (−32.8° F). The engine must not be subjected to extreme variations in temperature and humidity. Illustration 27 g02475658 Typical example Storage Period An engine can be stored for up to 6 months provided all the recommendation are adhered to. NOTICE Never bend the eyebolts and the brackets. Only load the eyebolts and the brackets under tension. Re- member that the capacity of an eyebolt is less as the angle between the supporting members and the ob- ject becomes less than 90 degrees. Storage Procedure Keep a record of the procedure that has been completed on the engine.
When it is necessary to remove a component at an angle, only use a link bracket that is properly rated for the weight. Note: Do not store an engine that has biodiesel in the fuel system. Use a hoist to remove heavy components. Use an adjustable lifting beam to lift the engine. All supporting members (chains and cables) should be parallel to each other. The chains and cables should be perpendicular to the top of the object that is being lifted. 1. Ensure that the engine is clean and dry. a. If the engine has been operated using biodiesel, the system must be drained and new filters installed. The fuel tank will require flushing.