Perkins — Perkins 854E-E34TA and 854F-E34T Industrial Engines Operation and Maintenance Manual

SEBU8726-03 75 Maintenance Section Fuel Specification Table 16 (1) To insure minimum cetane number of 40 a distillate diesel fuel should have minimum cetane index of 44 when“ASTM D4737” test method is used. A fuel with a higher cetane number is recommended to operate at a higher altitude or in cold weather (2) Density range allowed includes summer and winter diesel fuel grades. (3) Ultra Low Sulfur Diesel Fuel with sulphur content less than 0.0015 percent 15 PPM (mg/kg) must be used. Use of diesel fuel with higher than 15 PPM sulphur limit in these engines will harm or permanently damage emissions control systems.

Also, use of diesel fuel with higher than 15 PPM sulphur limit can shorten service interval. (continued) "Perkins Specification for Distillate Diesel Fuel" Property UNITS Requirements “ASTM”Test “ISO/Other”Test Aromatics %Volume 35% maximum “D1319” “ISO 3837” Ash %Weight 0.01% maximum “D482” “ISO 6245” Carbon Residue on 10% Bottoms %Weight 0.35% maximum “D524” “ISO 4262” Cetane Number(1) - 40 minimum “D613 or D6890” “ISO 5165” Cloud Point °C The cloud point must not exceed the lowest expected ambient temperature. “D2500” “ISO 3015” Copper Strip Corrosion - No.

3 maximum “D130” “ISO 2160” Distillation °C 10% at 238° C (460.4° F) maximum “D86” “ISO 3405” 90% at 350° C (662° F) maximum Density at 15 °C (59 °F) (2) kg/M3 800 minimum and 860 maximum No equivalent test “ISO 3675”“ISO 12185” Flash Point °C legal limit “D93” “ISO 2719” Thermal Stability - Minimum of 80% reflec- tance after aging for 180 mi- nutes at 150 °C (302 °F) “D6468” No equivalent test Pour Point °C 6 °C (42.8 °F) minimum be- low ambient temperature “D97” “ISO 3016” Sulfur(3) %mass 0.0015 % maximum “D5453” “ISO 20846” Kinematic Viscosity (4) MM2/S (cSt) The viscosity of the fuel that is delivered to the fuel injec- tion pump.

1.4 minimum and 4.5 maximum “D445” “ISO 3405” Water and sediment % weight 0.05% maximum “D1796” “ISO 3734” Water % weight 0.05% maximum “D1744” No equivalent test Sediment % weight 0.05% maximum “D473” “ISO 3735” Gums and Resins (5) mg/100mL 10 mg per 100 mL maximum “D381” “ISO 6246” Lubricity correctedwear scar diameter at 60 °C (140 °F). (6) mm 0.52 maximum “D6079” “ISO 12156-1” Fuel Cleanliness (7) - “ISO 18/16/13” “D7619” “ISO 4406” Trace Metals (8) mg/mg Max 1 or non-detectable “D7111” Oxidation Stability g/m^3 Max 25 “D2274” “ISO 12205” Hours(9) Min 20 “EN 15751”