Komatsu — CONTROL LEVERS AND PEDALS

. OPERATION EXPLANATION OF COMPONENTS PARKING BRAKE LEVER WARNING When parking the machine, always set the parking brake lever to LOCK position. This lever (5) is used to apply the parking brake. WORK EQUIPMENT LOCK LEVER WARNING When standing up from the operator's seat, always move the work equipment lock lever securely to LOCK position. If the blade control and ripper control levers are not locked and are 3 - 58 REMARK Before moving the parking brake lever to LO CK position, re turn the joystick (stee position.

When starting the ring, directional, and gear shift lever) to N engine, if the parking brake lever is not in LOCK position, th e limit switch is actuated a nd it is im possible to start the engine . touched by accident, If the work equipmen it may lead to serious injury t lock lever is not completely i or damage n LOCK po . sition, the lock may not be appl ied. position shown in the diagram. achine or when performing maintenance, always Check that it is in the position shown in the diagra When parking the m achine or when performing m ways lower the blade or ri pper to the ground, then set the work equipment lock lever to LOCK p osition.

Lever (6) is a device to lock the blade control an d ripper cont rol levers. When it is set to LOC K position, TILT, RAISE, L OWER, and FLOAT operations are lock REMARK gine, to ensure safety, always place the work equipment lock lever at LOCK position. When starting the en gine, to ensure safety, alw ays plac e the work equipment lock lever at LOCK position. If t he work equipmen t lock lever is not at LOCK position , the limit switch is actuated and the engine will not start.