Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION OPERATION CHECK BEFORE STARTING ENGINE, ADJUST WARNING 4. Check for leakage from fuel line. Check that there is no leakage of fuel or damage to the hoses and tubes. If any problem is found, carry out repairs. 5. Check for oil leakage of oil from power train case, final drive case, hydraulic tank, hoses, and joints Check that there is no oil leakage. If any problem is found, repair the place where the oil is leaking. Check for leakage of oil from the undercover. Check the ground for traces of oil leakage. 6. Check the undercarriage (track, sprocket, idler, guard) for damage, wear, loose bolts, or leakage of oil from rollers. If any problem is found, repair it.

3 - 90 WALK-AROUND CHECK Before starting the engine, walk around the mach ine and look at the underside of chassis for anything unusual l ike loose bolts and nuts, leakage of fuel, oil and co hydraulic system. olant. Also check the condition of the work equipment and the of dust at places that reach high temperature. the Also check for loose wiring, play, and collection Leakage of oil or fuel, or accumulation of flammabl e material around high temperature parts, such as the engine muffle r or turbocharger, may cause fire. pair it or contact your Komatsu distributor. Check carefully, and if any abnormality is found, re Do not get on or off the machine from the rear.

Usin g this position is dangerous because it is easy to slip and you cannot be seen from the operator's compartment. Always use the handrail and step at the side when getting on or off the machine. When checking the oil level, if the machine is inc lining, make it level before carrying out the check. chine and under the machine to check for loose nut or bolts, or Before starting the engine, look around the ma leakage of oil, fuel, or coolant, and check the con dition of the work equipment and hydraulic system. Check also for loose wiring, play, and collection of dust at place s which reach high temperatures. starting the engine each day. Always carry out the items in this section before 1.

Check for damage, wear, play in work equip ment, cylinders, linkage, and hoses. Check that there are no cracks, excessive w any problem is found, repair it. ear, or play in the work equipment, cylinders, linkage, or hoses . If 2. Remove dirt and debris from around the eng ine, battery, and radiator. Check for dirt accumulated around the engine etc.) around the battery, engine muffler, tur flammable materials are found, remove them and radiator.Also check for flammable material (dry leaves, twigs, bocharger, or other high temperature engine parts. If any dirt or . 3. Checking engine for leak of water, oil and air Check the engine for leak of engine oil, leak system.

If any leak is found, repair it. of water from the cooling system and leak of air from the suction