. OPERATION OPERATION STOPPING ENGINE allow it to cool down gradually, then stop it. The engine will stop 3 - 119 NOTICE If the engine is stop ped without allowing it to cool down , there i s dange that the service life o in emergencies, nev If the engine overhe f various parts of the eng er stop the engine sudde ats, do not stop it sudde ine will be reduced. Excep nly. nly. Run it at low speed to 1. Lower the wor k equipment to the gro und. 2. Place fuel con trol dial (1) in the low id le (MIN) p osition and run the engine at allow it to grad low idle speed for approximately 5 minutes to ually cool down. proximatel 3. Turn the key i n ignition switch (2) to OFF positi on (A). 4.
Remove the k ey from starting switch REMARK When engine s tarting switch (2) key i s turned to OFF p osition, the engine stops, but the machine's main power source is not tu This is a time l While this proc operation cond rned off immediately. ntroller to memorize the operation status and then terminate the system. ag provided for the co ess continues, the main power is maintained. The power holding time varies depending on the ition. cooling fan is used for a cleaning purpose, the machine's main power source is not turned off en if engine starting switch (2) key is turned to OFF position. Also when the immediately, ev This time lag is for 7 seconds.
en if engine starting s witch (2) k ey is t urned to OFF provided to protect the hydraulic circuit, and in t his case, the machine's m ain power is maintained