. OPERATION TRANSPORTATION For machine equipped with ripper the engine and set the parking brake lever to LOCK position (L) securely. 2. Set the work equipment lock lever to LOCK position (L) securely. 3. Install wire ropes, slings, etc. matched to the weight of the machine to the lifting points as shown in the above figure. Use protectors to prevent the wire rope from being cut on sharp corners and to prevent the wire rope from cutting into the machine bodywork. a spreader bar, select an ample width to prevent contact 3 - 161 Fit th e wire ropes at the center to both left and the right pivot shafts ( Hang the rear wire rope to ripper beam (3).
When lif ting the machine, stop it on a level place, then observe the follo 1. Stop NOTICE Use pr and to When with t 4. Afte r setting the wire ropes, lift up the machine and stop at 100 to 20 0 mm (3.9 to 7.9 in) above the ground , and che ck that the wire ropes are not slack and the machine is level, th en lift up slowly.