. MAINTENANCE SERVICE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING Coolant Interval for cleaning inside of cooling system and changing antifreeze coolant Komatsu genuine SUPERCOOLANT (AF-NAC) Every 2 years or every 4000 hours whichever comes sooner Komatsu genuine SUPERCOOLANT (AF-NAC) has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of coolant is essential. Komatsu machines are supplied with SUPERCOOLANT (AF-NAC). SUPERCOOLANT (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours.
As a basic rule, we do not recommend the use of any coolant other than SUPERCOOLANT (AF-NAC). If you use another coolant, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. To maintain the anticorrosion properties of coolant, always keep the density of coolant between 30% and 64%. When selecting coolant, investigate the lowest temperature in the past and decide the density for the coolant from the coolant density table below. When actually deciding the density for the coolant, set it approximately 10 ° C (50 ° F) below lowest temperature. The density must be over 30% at least.
If the density of obtained coolant is higher than the necessary density for lowest temperature, dilute it with adequate distilled water, and then fill it into the tank. If there is any unclear point, contact your Komatsu distributor. Coolant density table 4 - 24 Immediatel y after the en gine is stopped, the cooling wate r is at hi gh temperature and the radiator i s under hig h internal press ure. I f the radiator cap is removed in thi s condition an d the wa ter is drained, it may cause burns. To prevent this, wait for the temperature to g o down, then turn the cap slowly to release t he internal press ure. Start t he engine and cle an the insid e of the c ooling system .
When standing u p or le aving t he operator's seat, set the work equipment lock lever an d parking brake lever to the LOCK p osition. For de tails when starting the engine, see "CHE CKBEFORES TARTING ENGINE, ADJUS T(PAGE 3-90)" and "STARTIN GENGINE (PAGE 3-111)". at the front of the machine while the engine is running. There is danger of touching the fan. Never approach the fan at the front o f the mac hine while the engine i s running. There is danger of touching the fan Enteri ng under the mach ine for cleaning while the engine is running i s ver y dangerou s since t he machine may start suddenly. Never enter under the m achine while the engi ne is running.
Stop the machine on lev el ground when cle aning or cha nging th e coolan Clean th e inside of the c ooling system, cha nge the cool ant accordin g to t he ta ble below ° Minimum Temp ° C Above -10 - 15 -20 -25 -30 -35 -40 -45 -50 F Above 14 5 -4 -13 -22 -31 -40 -49 -58 Density (%) 30 36 41 46 50 54 58 61 64