. MAINTENANCE SERVICE PROCEDURE CHECK IDLER OIL LEVEL WARNING INSPECTION 1. Remove bolt (1), then remove guide plate (2) and shim (3). 2. Loosen plug (4) slowly. If oil oozes through the threads at this time, the quantity of oil is sufficient. Tighten plug (4). 3. If any oil does not flow out when plug (4) is removed, the quantity of oil is insufficient. In this case, ask your Komatsu distributor for repair. 4. Install guide plate (2) and shim (3) with bolt (1). 4 - 42 If the oil level in the idler is low, new oil must be added, and the machine bod y must be inclined i n this case. Since this w ork is dangerous, ask your Komatsu di stributor.
If the oil level in the idler is lo w, noise will be generated and there will be seizure, so che ck the oil level and a dd oi as follows. REMARK When removing shim (3) kee p it in a safe place and be careful not to lose it. REMARK When installing guide plate (2), install the same number and ved in Step 1. thickness of shim (3) as remo The optimum clearance ma made at the same time. For d y be obtained, if the adjustment is etails of adjusting the shim thickness, see "ADJUST IDLER CLEAR ANCE (PAGE 4-42)". ADJUST IDLER CLEARA NCE move forward and backward by an external force guide plates will be worn out.
Since the idlers are forced to move forward and backward by an external force guide pl ates will be worn out. Wear of these plates will caus e the vibration of idlers from side to side or inclination of th e idlers, and running off of track links from the idlers or u nevenly worn idler and links may result. Therefore, adjust the idlers a ccording to the following procedure. ADJUSTMENT 1. Travel for 1 or 2 meters on (A) between track frame ( right, inside, outside). 2. If the clearance (A) excee and pull out the shim to a to 1.0 mm (0.02 to 0.04 in Thickness of one shim is flat ground, then measure clearance 1) and guide plate (2) (4 places:
left, ds 4.0 mm (0.16 in), loosen bolt (3), djust the clearance at one end to 0.5 ). 1.0 mm (0.04 in).