. MAINTENANCE SERVICE PROCEDURE LOCATIONS FOR ADJUSTMENT AND NEED FOR ADJUSTMENT WARNING Angledozer 4 - 46 It is dangerous if th e work equipment moves by mistake when it i s being adjusted. Move the machine to a horizontal place, stop the machin e, and s et the work equipment in a stable condition. Then stop the engine and set the work equipment lock lever table condition. Then stop ever securely to the LOC K position. Straight tilt doz er Straight tilt pow er pitch doze Sigma d ozer itch dozer Sigma p ower p itch dozer 1. Adjust the pla y of each l ink ball joint at positions (1) to (4). (1) (2) (3) (4) Tilt brace, tilt cylinde r head, pitch cy Lift cylinde Center bra Trunnion 2.
Adjust the ten sion of center REMAR For details of the procedure for adjusting e ach location, se e the "ADJUSTING SH IMS AT TILT BRACE, TIL T CYLINDER HEAD , PITCH CYLINDER HEA "ADJUSTING SH IMS AT LIFT CYLINDER HEAD (PAGE 4-48)" "ADJUSTING SH IMS AT CENTER BRACE (PAGE 4-49)" "ADJUSTING SH IMS AT TRUNNION (PA GE 4-50)" "ADJUSTING TE NSION OF CENTER BRA CE (PAGE 4-51)"