Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE indicated with the arrow, then supply grease to that fitting with a grease pump. CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING install oil level plug (2) and oil filler plug (1). 4 - 58 GREASE EQUALIZER BAR Left and right, 1 places each . Remove all dirt from the top Clean the grease fitting indi REMARK Supply 3 shots of grease (O perate the grease pump lever 3 times) to each grease fitting, discharged through the seal l and check that grease is newly ip. arged through the lip, continue charged.

If grease is not newly disch supplying grease until it is dis If the blade is lowered to raise the idler 1 to 2 cm from the ground in order when carrying out l whole circumference of the p order when carrying out l ubrication, the grease will fill the in. GREASE EQUALIZER BAR CENTER PIN on the left side of the chassis. cated with the arrow, then supply (1 place) 1. 2. . Open the engine side cover Clean the grease fitting indi grease to that fitting with a g rease pump. REMARK If the blade is lowered to raise th e idler 1 to 2 cm from the ground in order when carrying out lubric ation, the grease will fill the whole circumference of the pin.

Th e oil is at high temperature im mediately after the machine has been operated. Wait for the oil to cool down before starting th e operation. inside the case, the oil or plug may fly out. the pressure. If there is still pressure remaining inside the case, the oil or plug may f ly Loosen the plug slowly to release . Stop the machine so that dra in plug (3) is directly at the bottom. . Remove oil level plug (2) a nd check whether the final drive edge of the plug hole. case is filled with oil to lower . I f the oil level is too low, add o il through the oil filler plug hole(1). . When oil starts to overflow fro m oil level plug (2), stop filling and