Komatsu — OPERATION

. SAFETY PRECAUTIONS FOR OPERATION 2 - 25 TRAVELING ON SLOPES pping over or slipping to the side, always do as follows. proximately 20 to 30 cm (8 to 12 in) e of emergency, lower the work mediately to help stop the machine. own a slope. Traveling at an angle ely dangerous. el across slopes. Always go down position of the machine, then travel ves, or wet steel plates with low opes there is a hazard that the never shift gear or place the dangerous not to use the braking lace the transmission in a low gear nhill. he braking effect of the engine as To prevent the machine from ti pping over or slipping to the side, al ways do as fo Keep the work equipment ap above the ground.

In cas equipment to the ground im Always travel straight up or d or across the slope is extrem Do not turn on slopes or trav to a flat place to change the on to the slope again. Travel on grass, fallen lea speed. Even with slight sl machine may slip. When traveling downhill, transmission at neutral. It is force of the engine. Always p before starting to travel dow Depress the brake or use t necessary. PRECAUTIONS WHEN OPERAT ING When using the machine, to prevent personal injury caused by d amage to the work equipment or by the m achine overturning due to overload permitted load for the struct ing, do not exceed the permitted performance of the machine or the maximum ure of the machine.

too close to the edge of cliffs. When making embankments or landfills, or when mp 1 pile, then use the next pile of soil to push the first pile. ximum Be careful not to approach mbankments or dropping soil over a cliff, du mp 1 pile, then use the next pile of s oil to push the The load suddenly becomes lighter when the soil is pushed ove r a cliff or whe n the machine reaches th e top of a slope. When this happens the speed. , there is danger that the travel spe ed will sudden ly increase, so be sure to reduce nly either side of the blade loaded, its tail may swing. Take care. If the machine moves with o nly either side of the blade loaded, i ts tail may sw ing. Take care.

METHOD OF USING BRAKES When the machine is travelin g, do not rest your foot on the brake pedal. If you travel with your foot resting on the pedal, the brake will always be applied, and this will cause the b rakes to over heat and fail. Do not depress the brake pe When traveling downhill, us