D 2011 w Fuel system TD 2011 w, TCD 2011 w W 07-03-01 Renewing the injection lines Commercial available tools: – Dog wrench. . . . . . . . . . . . . . . . . . . 8018 Danger! Wait 30 seconds after switching off the engine before working on the fuel system. Special tools: – Plugs/caps . . . . . . . . . . . . . . . . . 170160 Attention! Pay attention to utmost cleanliness when working on the fuel system. Remove residue paint and particles of dirt before removing. Clean the respective affected parts care- fully. Blow damp areas dry with compres- sed air. Observe the safety regulations and natio- nal specifications for handling fuels.
Close all connections immediately after opening with new, clean plugs/caps. Do not remove plugs/caps until immedia- tely before assembling. Collect leaking operating substances in suitable vessels and dispose of according to regulations. Injection pipes may not be bent. After all work on the fuel system, it must be bleeded - see the operation manual, chap- ter "6 Fuel system“. 6 Removing injection pipes z Unscrew lock nuts (1) with dog wrench. 1 © 47653-0 © 12/2008 17819-001 1/6