D 2011 w Fuel system TD 2011 w, TCD 2011 w W 07-10-06 Removing and installing fuel pipes Commercial available tools: – Hose clip pliers . . . . . . . . . . . . . . . . 8011 – Torx tool set . . . . . . . . . . . . . . . . . . 8189 – Spring band pliers. . . . . . . . . . . . . . 9090 Danger! Wait 30 seconds after switching off the engine before working on the fuel system. Special tools: – Plugs/caps . . . . . . . . . . . . . . . . . 170160 Attention! Pay attention to utmost cleanliness when working on the fuel system. Remove residue paint and particles of dirt before removing. Clean the respective affected parts care- fully. Blow damp areas dry with compres- sed air.
Observe the safety regulations and natio- nal specifications for handling fuels. Close all connections immediately after opening with new, clean plugs/caps. Do not remove plugs/caps until immedia- tely before assembling. Collect leaking operating substances in suitable vessels and dispose of according to regulations. After all work on the fuel system, it must be bleeded - see the operation manual, chap- ter "6 Fuel system“. – Fitting compound DEUTZ AP1908 6 Removing fuel pipes z Unscrew screws (1). 1 © 47551-1 © 12/2008 17823-001 1/8