D 2011 w Job card overview TD 2011w, TCD 2011 w Sorted alphabetically 5 © 12/2008 19488-001 3/12 Activity Job card Maintenance group Checking piston overhang W 01-04-09 Cylinder head Checking the compression pressure W 00-02-06 General Checking the thermostat (in the removed state) W 09-08-01 Cooling system Disassembling, assembling and checking the rocker arm and rocker arm bracket W 01-02-06 Cylinder head Installing and removing charge air pressure-depen- dent full load stop W 07-10-08 Fuel system Mounting engine on assembly block and demoun- ting W 00-05-01 General Removing and install the charge air line W 06-02-03 Exhaust system/Charging Removing and installing cylinder head W 01-04-04 Cylinder head Removing and installing fuel pipes W 07-10-06 Fuel system Removing and installing temperature transmitter W 09-12-01 Cooling system Removing and installing the control line W 08-16-01 Lube oil system Removing and installing the coolant pump W 09-07-08 Cooling system Removing and installing the crankcase bleeding W 03-01-11 Crankcase Removing and installing the exhaust gas collection pipe (Exhaust gas recirculation) W 06-09-08 Exhaust system/Charging Removing and installing the exhaust gas return pipe W 06-09-07 Exhaust system/Charging Removing and installing the exhaust gas return val- ve W 06-09-06 Exhaust system/Charging Removing and installing the exhaust line W 06-01-05 Exhaust system/Charging Removing and installing the flywheel W 12-06-01 Other components Removing and installing the fuel filter console W 07-10-08 Fuel system Removing and installing the fuel injectors W 07-07-01 Fuel system Removing and installing the fuel supply pump W 07-11-01 Fuel system Removing and installing the generator W 13-02-03 Electrical system Removing and installing the glow plug W 13-06-02 Electrical system Removing and installing the heating plugs W 13-06-01 Electrical system Removing and installing the hydraulic pump W 12-08-02 Other components Removing and installing the intake manifold W 06-07-03 Exhaust system/Charging Removing and installing the lifting magnet (charge air pressure-dependent full load stop) W 07-10-08 Fuel system Removing and installing the lifting magnet (Engine shutdown) W 11-00-03 Monitoring system Removing and installing the lifting magnet (Start amount release) W 07-02-07 Fuel system Removing and installing the lubricating oil cooler W 08-08-02 Lube oil system