D 2011 w Cylinder head TD 2011 w, TCD 2011 w W 01-02-06 Checking the rocker arm z Prepare internal measuring device: Mount probe bolt for the appropriate measuring range in the internal measuring device. Mount dial gauge with approx. 1 mm pre-tension in the internal measuring device. Set micrometer gauge to 18 mm. Balance the internal measuring device between the test surfaces of the micrometer gauge and set the dial gauge at the reversal point of the pointer to "0". 6 © 34768-2 z Insert internal measuring device. z Measure rocker arm bore. Outlet 18 mm + 0.27 Inlet 18 mm + 0.27 When the wear limit is reached the rocker arm must be renewed.
© 39032-1 Checking the rocker arm pin z Measure diameter with micrometer gauge. 17,97 mm + 0.01 0.01 When the wear limit is reached the rocker arm bracket must be replaced. © 39148-1 © 12/2008 17772-001 3/6