Komatsu — LOADING AND UNLOADING WITH TRAILER

TRANSPORTATION OPERATION LOADING AND UNLOADING WITH TRAILER WARNING When loading or unloading on to a trailer, set to low speed, and do not operate the travel speed selector switch during the operation. Run the engine at low idling, set to low speed, and operate the machine slowly when loading or unload- ing. Select firm, level ground when loading or unloading the machine. Maintain a safe distance from the edge of the road. Use ramps with ample width, length, thickness, and strength and install them at a maximum slope of 15є. When using piled soil, compact the piled soil fully and take action to prevent the slope face from collapsing.

Remove all mud and dirt from the machine tracks before starting in order to prevent the machine from slipping on the ramps. Be sure that the ramp surface is clean and free of water, snow, ice, grease, or oil. Never correct your steering on the ramps. There is danger that the machine may turn over. If necessary, drive off the ramps, correct the direction, then enter the ramps again. Do not use the work equipment for loading and unloading operations. It is dangerous. When on the ramps, do not operate any lever except the travel lever.

The center of gravity of the machine will change sud- denly at the joint between the ramps and the track or trailer, and there is danger of the machine losing its balance. Travel slowly over this point. When swinging the upper structure on the trailer, the trailer is unstable, so pull in the work equipment and swing slowly. If the sliding door of the cab is closed or open, always check that it is locked in position. The operating effort when opening or closing the door suddenly changes when the machine is on a ramp or platform, so never open or close the door in such conditions. When loading or unloading, always use ramps or a platform and carry out the operation as follows. 3-90