Komatsu — LIFTING MACHINE

OPERATION TRANSPORTATION When lifting the machine, carry out the operation on flat ground as follows. 1. Swing the upper structure so that the work equipment is at sprocket (1) end. 2. Extend the bucket cylinder and arm cylinder fully, then lower the work equipment to the ground as shown in the diagram on the right using the boom cylinder. 3. Stop the engine, check that there is nothing around the operator's compartment, then get off the machine. Close the cab door and front glass securely. 4. Pass wire ropes between the 1st and 2nd track rollers from the front and between the 1st and 2nd track rollers from the rear. 5.

Set the lifting angle of the wire rope to 30є to 40є, then lift the machine slowly. 6. After the machine comes off the ground, check carefully that the machine is balanced, then lift slowly. 3-97