MAINTENANCE PROCEDURE MAINTENANCE ADJUST BUCKET CLEARANCE WARNING It is dangerous if the work equipment moves by mistake when the clearance is being adjusted. Set the work equipment in a stable condition, then stop the engine and lock the safety lock lever securely. 1. Set the work equipment to the position shown in the dia- gram at right, stop the engine and set the lock lever to the locked position. 2. Shift O-ring (1) of the linkage and measure the amount of play "a". Measurement is easier of you move the bucket to one side or the other so all the play can be measured in one place. Use a gap (clearance) gauge for easy and accurate mea- surement. 3.
Loosen the four plate fixing bolts (2) and loosen plate (3). Because it uses split shims, you can carry out the opera- tion without removing the bolts entirely. 4. Remove shim (4) corresponding to the amount of play "a" measured above. A set of shims is composed of two pieces and the thick- ness of each shim (4) is 0.5 mm (0.020 in). 5. Tighten the four bolts (2). If the bolts (2) are too stiff to tighten, pull out ring plate (5) for easier tightening. 4-42