MAINTENANCE MAINTENANCE PROCEDURE EVERY 250 HOURS MAINTENANCE Maintenance for every 50 hours service should be carried out at the same time. CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. If there is still pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. Prepare a container to catch draining oil and a hexagonal wrench. 1. Set so that plug (G) is at the top, with plug (G) and plug (P) perpendicular to the ground. 2.
Set a container under plug (P) to catch the oil. 3. Using a hexagonal wrench, remove plug (G) and check that the oil level is near the bottom of the plug hole. 4. If the oil level is low, use the hexagon wrench to remove plug (F), then add oil through the hole of plug (F). Add engine oil until the oil flows out from plug hole (G). 5. After checking, install plug (F) and plug (G). 4-57