MAINTENANCE MAINTENANCE PROCEDURE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS AND CON- DENSER FINS WARNING If compressed air, high-pressure water, or steamhit your body directly, or they cause dirt or dust to be blown up, there is a hazard of serious injury. Always use safety glasses, dust mask, or other protective equipment. NOTICE When using compressed air, if the nozzle is brought too near the fins, the fins may be damaged. Carry out the cleaning from a reasonable distance to prevent damage to the fins. Do not direct the jet directly at the core. If the fins are damaged, it will cause leakage of water and over- heating.
On dusty jobsites, carry out this inspection every day, regardless of the maintenance interval. 1. Open engine food (1). 2. Remove left cover (2) of counterweight. 3. Use compressed air to blow off the mud, dust, or leaves clogging the radiator fins, oil cooler fins and condenser fins (3) (Machine equipped with car cooler). Steam or water can be used in place of compressed air. 4. Check the rubber hose. Replace with a new one if the hose is found to have cracks or to be hardened by age- ing. Further, check hose clamps for looseness. LUBRICATE SWING CIRCLE (2 POINTS) 1. Lower the work equipment to the ground. 2. Using a grease gun, pump in grease through the grease fittings shown by arrows.
3. After greasing, wipe off all the old grease that was pushed out. 4-67