Komatsu — CHANGE OIL IN SWING MACHINERY CASE

MAINTENANCE PROCEDURE MAINTENANCE EVERY 1000 HOURS MAINTENANCE Maintenance for every 50, 100, 250 and 500 hours service should be carried out at the same time. CHANGE OIL IN SWING MACHINERY CASE WARNING The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. Container to catch drained oil: Min. 1.6 liters (0.42 US gal) capacity Refill capacity: 1.6 liters (0.42 US gal) 1. Set an oil container under drain valve (P) under the machine body. 2. Loosen drain valve (P) under the body, drain the oil, then tighten the drain valve again. Tightening torque for drain plug (P):

44 to 93 N•m (4.5 to 9.5 kgf•m, 32.5 to 68.7 lbft) 3. Open cover (1) at the right side of machine, remove dip- stick (G) and air bleed plug (2), then add the specified amount of engine oil from oil filler (F). 4. Wipe off oil on the dipstick with a cloth. 5. Insert dipstick (G) into the gauge pipe thoroughly and then pull out it again. 6. When the oil level is between the H and L marks, on dip- stick (G), it is normal. If the oil does not reach the L mark, add more oil through oil filler (F). 7. If the oil level exceeds the H mark, drain the excess engine oil from drain valve (P), and check the oil level again.

REMARK When checking the oil level after the engine has been operated, for at least 15 minutes after stopping the engine before checking. If the machine is at angle, make it horizontal before checking. 4-70