Komatsu — CHECK ENGINE VALVE CLEARANCE, ADJUST

MAINTENANCE PROCEDURE MAINTENANCE EVERY 2000 HOURS MAINTENANCE Maintenance for every 50, 100, 250, 500 and 1000 hours service should be carried out at the same time. CHECK OIL LEVEL IN PTO GEAR CASE, ADD OIL WARNING The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. If there is still pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. 1. Remove oil inspection plug (G) and check that the oil is near the bottom of the check hole.

If the oil level is low, add oil through oil filler (F) until the oil level is close to the bottom of the hole of plug hole. 2. Install plug (G). CHECK ALTERNATOR, STARTING MOTOR The brush may be worn, or the bearing may have run out of grease, so contact your Komatsu distributor for inspection or repair. If the engine is started frequently, carry out inspection every 1000 hours. CHECK ENGINE VALVE CLEARANCE, ADJUST As special tool is required for removing and adjusting the parts, you shall request Komatsu distributor for service. 4-72