ATTACHMENT INSTALLATION COMBINATION TABLE ATTACHMENTS AND OPTIONS ATTACHMENT INSTALLATION COMBINATION TABLE WARNING Depending on the type or combination of work equipment, there is danger that the work equipment may hit the cab or machine body. When using unfamiliar work equipment for the first time, check before starting if there is any danger of interference, and operate with caution. ATTACHMENT COMBINATIONS This table lists the combination of attachments which can be installed to the standard arm, short arm and long arm. : Can be used : Can be used only for light-duty work :
Cannot be used NOTICE When the long arm is equipped, if the bucket is pulled in to the machine body, the arminterferes with the body. Operate the long arm carefully. When the boom is fully lowered during oblique digging, the boom interferes with the undercarriage. Operate the boom carefully. Categories of use For general digging: Digging or loading sand, gravel, clay etc. For light duty digging: Digging or loading dry, uncaked earth and sand, mud etc. For loading work:
Loading dry, loose earth and sand 6-16 Name Tooth mounting pin Capacity (m3) SAE/CECE Outside width (bucket body) (mm) Outside width (side cutter) (mm) Use Standard arm Long arm Narrow bucket Vertical 0.09/0.08 350 (14") 450 (18") Narrow digging Narrow bucket Vertical 0.13/0.11 450 (18") 550 (22") Narrow digging Narrow bucket Vertical 0.20/0.18 550 (22") 650 (26") Narrow digging Standard bucket Vertical Horizontal 0.28/0.25 650 (26") 750 (30") General digging Light duty bucket Vertica 0.34/0.30 760 (30") — Loading