SK1050 Operator’s Manual Service - 79 50 Hour Check Fan Belt for Tension and Damage 1 Check belt tension after 50 hours. Belt is properly tensioned when it moves about 1/4-3/8” (7-9 mm) when pushed at the long span. Replace the belt when it is worn and sinks into the pulley groove. 2 Adjust Tension 1. Loosen two alternator bolts (shown). 2. Adjust position as needed. 3. Tighten bolts. 1 4. Check tension. t53om012h.eps t53om012h.eps Check Fuel Hose and Clamp Bands Check fuel hose and clamp bands every 50 hours. If the clamp is loose, apply oil to the threads and retighten it. If the hose is worn, replace it. Bleed the fuel system if the hose and/or clamp is changed.
Check Radiator/Fluid Cooler Check radiator/hydraulic fluid cooler for dirt, grass, and other foreign matter every 50 hours. Clean out with compressed air or spray wash if required. Be careful not to damage fins with high- pressure air or water. Check more often if operating in dusty or grassy conditions. Check radiator hoses for wear. Check hose clamps for proper tightness. nd p is t43om017w.eps s. if igh- t35om020w.eps