SK1050 Operator’s Manual Service - 87 As Needed As Needed Change Air Filter Change air filter when red band on indicator (1) is visible. Replace secondary element (4) every third change of primary element (3) or any time primary element has become damaged. To change: 1. Open air filter housing at latches. 2. Remove primary element. 3. Wipe inside of housing and end cup (2) and clean dust ejector valve. 4. Insert new secondary element if necessary and ensure it is seated correctly. 5. Insert new primary element. 6. Latch air filter housing with dust ejector facing downward. 7. Reset air filter service indicator. NOTICE: Only open the air filter housing when red band on indicator is visible.
Change the elements. Do not attempt to clean them. Improperly installed primary element can lead to premature engine failure. Compressed air or water may damage filter elements. Tapping filter elements to loosen dirt may damage the elements. Location Task Notes Change air filter Drain water separator filter Adjust attachment drive foot control Adjust idler roller bearings Check engine compartment for debris Check battery Charge battery 3 1 2 4 t35om032w.eps