SK1050 Operator’s Manual Service - 89 As Needed Adjust Idler Roller Bearings Adjust idler roller bearings to keep dirt, grass, and other foreign matter from damaging bearings as needed when hubs become loose. 1. Release track tension. See “Check Track Tension” on page 76. 2. Remove lug nuts (6) to remove dust cap cover (5) and retainer (8). 3. Remove bearing protector (7). 4. Remove cotter pin (1). 5. Ensure bearings are properly seated by tightening castle nut (4) to 30-40 ft•lb (40.7- 54.2 N•m) while turning the hub. IMPORTANT: Do not move the hub after this step is completed. 6. Loosen the castle nut (4). 7. Hand-tighten the castle nut. 8. Insert the cotter pin into the wheel spindle (3).
NOTICE: If hole is visible in slot but cotter pin cannot be inserted, slightly loosen or tighten castle nut to align slot with hole and insert cotter pin. If hole is not visible in slot, loosen to next available slot and install cotter pin. 9. Bend the legs of the cotter pin over the top of the spindle. IMPORTANT: The hub should not have noticeable movement when rocked back and forth. 10. Replace bearing protector, cover, retainer, and lug nuts. Tighten lug nuts to 80 ft•lb (108 N•m). 11. Adjust track tension.