John Deere 400 6076 — John Deere 400 6076 User Manual

Cylinder Block, Liners, Pistons and Rods/Remove and Clean Piston Cooling Orifices COMPLETE DISASSEMBLY OF CYLINDER BLOCK (IF REQUIRED) If complete inspection and “Hot Tank” cleaning of cylinder block is required, refer to the appropriate group for removal of all external and internal mounted components listed below: 4. Remove timing gear train and camshaft. (Group 16) 5. Remove fuel injection pump and fuel filter assembly. (Group 35) 1. Remove crankshaft and pulley if not previously removed. (Group 15) 6. If necessary to “Hot Tank” the block, remove oil gallery plugs, water gallery plugs, piston cooling orifices and the engine serial number plate.

(See REMOVE AND CLEAN PISTON COOLING ORIFICES, later in this group.) 2. Remove all remaining lubrication system components. (Group 20) Remove starting motor. 3. Remove water pump and all remaining cooling system components. (Group 25) RG,CTM42,G10,6 -19-22JUL94 REMOVE AND CLEAN PISTON COOLING ORIFICES 1. Remove all six piston cooling orifices (A) and inspect each cooling orifice to make sure it is not plugged or damaged. 10 29 2. Use a soft wire and compressed air to clean orifice. Replace, if condition is questionable. IMPORTANT: A piston cooling orifice failure could cause damage to pistons, piston pins, rod pin bushings, and liners.

If a piston cooling orifice is left out, low or no oil pressure will result. RG5811 -UN-12AUG91 RG,CTM42,G10,7 -19-29OCT92 CTM42 (24MAR95) 10-29 6076 Diesel Engines—S.N. (500000— ) 160101 PN=114