Safety/Safety REMOVE PAINT BEFORE WELDING OR HEATING 00 5 Avoid potentially toxic fumes and dust. Hazardous fumes can be generated when paint is heated by welding, soldering, or using a torch. TS220 -UN-23AUG88 Do all work outside or in a well ventilated area. Dispose of paint and solvent properly. Remove paint before welding or heating: • If you sand or grind paint, avoid breathing the dust. Wear an approved respirator. • If you use solvent or paint stripper, remove stripper with soap and water before welding. Remove solvent or paint stripper containers and other flammable material from area. Allow fumes to disperse at least 15 minutes before welding or heating.
DX,PAINT -19-03MAR93 AVOID HEATING NEAR PRESSURIZED FLUID LINES Flammable spray can be generated by heating near pressurized fluid lines, resulting in severe burns to yourself and bystanders. Do not heat by welding, soldering, or using a torch near pressurized fluid lines or other flammable materials. Pressurized lines can be accidentally cut when heat goes beyond the immediate flame area. TS953 -UN-15MAY90 DX,TORCH -19-03MAR93 ILLUMINATE WORK AREA SAFELY Illuminate your work area adequately but safely. Use a portable safety light for working inside or under the machine. Make sure the bulb is enclosed by a wire cage.
The hot filament of an accidentally broken bulb can ignite spilled fuel or oil. TS223 -UN-23AUG88 CTM42 (24MAR95) 00-5 6076 Diesel Engines—S.N. (500000— ) DX,LIGHT -19-04JUN90 160101 PN=10