Lubrication System/Clean, Inspect, and Install Engine Oil Cooler CLEAN, INSPECT, AND INSTALL ENGINE OIL COOLER RG5904 -UN-20AUG91 A—Oil Conditioning Housing B—Gasket C—Oil Cooler D—Gasket 1. Once oil cooler is removed, scrape off all old gasket material from cooler and block. NOTE: If mixing of oil and coolant is suspected, pressure test oil cooler in liquid and compressed air. Use 140—170 kPa (1.4—1.7 bar) (20—25 psi) air pressure for testing. Replace oil cooler as necessary. 2. Clean all parts with clean solvent and a brass wire brush. Dry with compressed air. 3. Inspect all parts for serviceability. Replace parts as necessary. 4.
Using new gaskets install oil cooler/oil conditioning housing. See INSTALL OIL FILTER AND OIL CONDITIONING HOUSING, earlier in this group. 20 8 RG,CTM42,G20,12-19-09OCT92 CTM42 (24MAR95) 20-8 6076 Diesel Engines—S.N. (500000— ) 160101 PN=211