Fuel System/Remove Rotary Fuel Injection Pump—Stanadyne DB4 REMOVE ROTARY FUEL INJECTION PUMP—STANADYNE DB4 IMPORTANT: Never steam clean or pour cold water on an injection pump while pump is running, or while it is still warm. To do so may cause seizure of pump parts. 1. Clean injection lines and area around injection pump with cleaning solvent or a steam cleaner to keep debris out of fuel system. RG6456 -UN-22OCT92 2. Remove injection pump timing gear cover (shown removed). 3. Rotate engine flywheel (in normal running direction) until No. 1 piston is at “TDC” of its compression stroke, and JDE81-4 Timing Pin enters hole in flywheel.
“V” marks on injection pump drive gear (A) and drive gear access opening (B) MUST align. If marks do not align, remove timing pin and rotate engine one full revolution until timing pin enters hole in flywheel again. “V” timing marks should now align. RG,CTM42,G35,84-19-28OCT92 4. Disconnect shut-off cable and speed control rod. 5. Disconnect fuel leak-off line (A). 6. Disconnect fuel supply line (B). 7. Disconnect fuel delivery (pressure) lines (C), using a suitable 17 mm deep-well crowsfoot socket. RG6461 -UN-26OCT92 35 33 CTM42 (24MAR95) 35-33 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G35,85-19-28OCT92 160101 PN=310